MOZA Air 2 4-Axis Electronic Gimbal Stabilizer for Mirrorless and DSLR Cameras with Hard Shell Shock-Resistant Case (Max Payload: 4.2kg/9.0lbs)

Product Information

The software will automatically identify the device and load the firmware, press the upgrade button, and wait for about 10 seconds Tap Remote to access on screen controls over gimbal movement, Speed, Re- Center, Selfie, Rec&STop, and Photo Use the mini tripod as a handle extension to add extra height for a jib shot and to help spread out the weight of the gimbal.

MOZA Air 2 Gimbal Stabilizer The Complete Guide to the MOZA Air 2 Gimbal Stabilizer

Moving along to the roll arm leads to the roll axis. Adjust the roll arm in and out so the roll arm no longer rises or falls.

To decide whether to buy a Moza Air 2 gimbal, I will need the information I asked above and in the first message. The Air 2 features a clear line of sight to the camera’s monitor. By shorting the yaw arm the roll motor is placed below the camera. Doing so gives the user a clear line of sight to camera’s monitor. With the MOZA Air2, following the action is uninterrupted. We are sorry that after consulting our supervisor, we cannot provide you the asking information as these information are sensitive information to us, Chapter 4: Overview of the MOZA Master App: How to configure turn gimbal, auto tune explain oscillations how change effect gimbal go over all settings

MOZA Air 2 4-Axis Electronic Gimbal Stabilizer for Mirrorless

There are many facebook users of the moza and also people on another forum saying they get problems and fried their gimbals with long term use, I am not the only one. It might be that many of Gudsen's gimbals are defective though, I don't know. Lauri Astala wrote:Hi Keith, thanks for your reply! How do you know the 12V DC Out is 2 Amps? Is this official Moza info? It would really be helpful to know the real wattage limit. If you need to restore the gimbal to default settings. You can access Configuration and select Set Default. Or from the gimbals handle configuration. To use the Dial on the gimbal’s handle to control the iFocus, press M button to select channel F1. To control focus over usb, select channel Fe.This knob adjusts for the vertical position of camera’s center of mass. Note most first time gimbal users improperly balance this axis. DO NOT leave this adjustment in the lowest position. The last adjustment is the yaw axis. Hold the gimbal horizontal and take note of the roll motor’s position. If the roll motor’s position is high than the yaw arm will need to be pulled out, if the roll motor’s position is below than the yaw arm need to pushed in. Sport Gear: To select sport gear mode press the Fn button. Pan will disply a Q to indicate Sport Gear mode. Now when holding in the smart trigger the gimbal’s motors will dramatically increase response time. Sport gear mode is essential when capturing a fast moving subject. I'm a tester of their products! It's official. Their main support guy told me this information. It's 12V/2A, which is 24 Watts. I just found a letter from BM support saying that the BMPCC4K draws 20 Watts. I think that you have a faulty gimbal. I powered the camera through the Weipu port for 4 hours when I first received it in Dec and never had any problems. Are there two “versions” of Moza Air 2, one that has a 12V DC OUT and the other with a 16.8V DC OUT?