Coredy Robot Vacuum Cleaner, 3-in-1 Vacuuming Sweeping and Mopping, Wi-Fi, App Controls, 2200pa Strong Suction, Slim, Quiet, Self-Charging Robotic Hoover Cleaner, Cleans Hard Floor to Carpet

Product Information

However, there is one thing you can try. You can power cycle the device. You can do this by holding the power button for 20-30 seconds. It will hard reset the machine, and this might work for you.

This robotic vacuum comes with a 3200mAh battery. Therefore, it can work continuously for 2 hours after each charge. ( 1) The cliff sensors are located on the side of the machine near the bumper, as shown in the image below. Intelligent Mopping Cleaning System : R750 robot vacuum cleaner adopts latest mopping technology, equipped with an electronically controlled water pump, automated monitor and control the water level according to the dryness and humidity of the floor without spillage, you can get to enjoy a completely clean home from a intelligent mopping system.(a water tank and cleaning mop cloth included)Has TWO (2) side brushes (right and left) versus one side brush on my other cleaners [bobSweep Pro and iRobot Roomba].

If the charging base indicator fails to light up, repair or replace the charging base. Also, if there is no beep when the robot sits on the charging base, repairing or replacing the charging base is needed. Error 9 indicates that the front infrared sensor of the robot has dust and needs proper cleaning. On the other hand, Error 10 means that the right wall sensor has dust accumulation. What do Errors S1, S2, S3, S4, S5, and S6 indicate in Coredy L900X, and how to solve these issues? Most models have three cliff sensors. Two are located on the sides, and one is located on the top corner of the vacuum cleaner. Wipe them with a clean microfiber cloth. Be gentle with them as rubbing too hard can damage the sensors.Solution: First of all, make sure the battery is properly connected. Also, higher or lower battery temperatures show the S1 error. Therefore, you need to wait until the battery hits the normal temperatures and then restart the device. I set the unit on AUTO and let it clean my hardwood floors in living room, kitchen, dining room, AS WELL as the halls to front door & garage door. Unclip all the cables and lift the circuit board. Make sure you record the procedure so you can reinstall everything at the right place. I used the scheduling button to have the cleaner automatically run at 7:00 am the next morning. I ran and returned to the home base automatically. I did this for two days; working flawlessly. I also directed the Robot to clean the third day, via Alexa and it again worked flawlessly - returning the the charging base upon completion.